31 مه

It refers to the various parts that make up the mould structure

In order to ensure accurate centering belonging to the movable and fixed moulds for the duration of mould clamping, guides must be provided inside mould. 5-6 mm from the side of the die. 2 mm along with a width of 1.

The latter is a shallow groove that has a depth of 0. In addition, the clearance between the ejector rod as well as ejector hole, the clearance between the ejector plate and also the ejector plate and the central, and the like can always be used for exhaust. In the mould opening process, an ejector mechanism is necessary to push or pull the plastic material product and its aggregate in the flow path. In your push rod, a reset rod is usually fixed, and the reset rod resets the push plate when the movable and fixed moulds usually are closed.

It refers to the various parts that make up the mould structure, including: plenty of parts for guiding, stripping, central pulling, and parting. In the injection mildew, four sets of guide columns and guide bushes are usually used to form the guideline parts. The fixed plate plus the push plate are pushed out to hold on to the push rod. 03-0..

The position of the Bathtub Moulding exhaust port cannot be facing the operator to avoid accidental ejection of molten content. Through the injection, the exhaust hole will not likely leak much molten material, because of the molten material will cool along at this place and solidify your channel. Such as before and following your splint, front and rear buckle web theme, bearing plate, pressure column, manual column, stripping template, stripping rod and return rod etc.

Sometimes it is necessary to line the inner and outer taper surfaces that are matched amongst each other on the movable mould and also the fixed mould to assist ranking.Below normal circumstances, the vent hole can be located either by the end of the melt flow inside cavity or on the parting surface belonging to the mould

25 مه

The injection mold consists of two parts: the moving mold

. The moving mold is installed for the moving mold of the shot molding machine, and the fixed mold is installed about the fixed mold of the injection molding machine. When the mold is usually opened, the movable mold and also the fixed mold are separated to remove the plastic product.. In order get rid of the heavy mold design in addition to manufacturing workload, most of this injection molds use standard mildew bases.

Yan Hua has also been emphasizing studios as a platform with the training of skilled talents. The gating system as well as the molded parts are in direct contact when using the plastic and change with the particular plastics and products. They is also the most complex and most varied parts from the mold and require the highest finish and accuracy on the part.

The injection mold consists of two parts: the moving mold and also the fixed mold. The skills will be better passed on available as “passing and helping the band” through the development of fitter skill level training, educator training, technical exchange research and skill competitions.

The mold is mainly constructed from a pouring system, a heat range control system, a molded part as well as a structural part. During the shot molding, the movable mold plus the fixed mold are closed to make a casting system and any cavity.

Although the structure of the mold may vary from the variety and performance of your plastic, the shape and structure from the plastic product, and the sort of injection machine, the basic structure may be the same.At the moment, the “Suihua Model Worker Technology Studio” has 8 members, which 50% of the members have been employed by the company throughout master and above technical opportunities